Linksys, A division of Cisco Systems, Inc.


Product:           WAG300N (Annex A) 

Classification:    Firmware Release History

Release Date:      26 April 2007

Firmware-Version:  1.01.06 (ETSI)

NOTE:  Not for use with Annex B models of the WAG300N
____________________________________________________________

1.01.06
- Adds Setup Wizard Enable/Disable feature on UI
NOTE: Feature must be enabled to successfully run setup wizard to configure the gateway
- Fixes device reboot time
- Fixes issue with Daylight Savings Time setting for new D.S.T. dates
- Fixes issue with local IP address being the same as the WAN IP address
- Fixes issue with Security information disclosure for UDP port scan packet
- Fixes issue with Wireless MAC help page clarity
- Fixes issue with device not completely reloading UI after reboot
- Fixes issue with wireless settings modification ability when feature is disabled
- Fixes issue with discrepancy between QoS help text and GUI with Ethernet ports
- Fixes issue with incorrect MTU size range
- Fixes issue with Remote Management port value being checked when feature is disabled
- Fixes issue with Access Restrictions port range to extend max from 65534 to 65535
- Fixes issue with Remote Management not functioning when Management via WLAN is disabled
- Adds help text specifying the use of HTTP protocol for Remote Management connections
- Adds help text for ADSL modulation settings
- Adds prompt message to request user to change default password when enabling remote management
- Adds English, German, French GUI language configuration without firmware upgrade required

1.01.04
- Fixes issue with CD Setup wizard configuration of WebUI language
- Fixes issue with Wireless MAC filter table refreshing when new MAC address is added to the list
- Fixes typo with DDNS status information display
- Fixes prompt display of invalid MAC Address entry on the QoS page
- Fixes connection issue with WPA encryption
- Fixes UPnP display of incorrect connection rate
- Fixes issue with WEP key length restrictions
- Fixes issue with WPA/WPA2 restriction allowing entry of <8 characters for Pre-Shared Key
- Fixes issue with firmware upgrade progress display on WebUI

1.01.01
- Firmware with German, French, or English web UI.  Use the 
  firmware upgrade utility to upgrade from v1.01.00 to v1.01.01

1.00.00
- Initial Release


General Notes: 
- Disconnect all wireless clients from the Gateway during 
  the upgrade process. Make sure no wireless clients 
  attempt to associate with the Gateway until the upgrade 
  process is complete.  
