RV042 Firmware Revision History

v1.3.6.4	(2005/05/05 13:44:53)

1. Improved the connectivity for the Linksys QuickVPN client. 
	In rare case's, especially setting up both Group VPN and QuickVPN clients, the QuickVPN client may send an IPSec request packet to the 	RV042 very quickly after the SSL negotiation completed. This caused the RV042 to fail to establish a QuickVPN connection in time.
2. Solved the problem that remote user failed to ping RV082s WAN IP even if the Block WAN Request is disabled. This problem occurred only on 
v1.3.6.3 and PPPoE connection type. 
3. Add new feature: Support AES-128/AES-192/AES-256 and DPD. 

v1.3.6.3	2005/04/20

1. Solved the problem which caused the QuickVPN client connection failure when Load Balancing is enabled.
2. Changed the subnet mask of PPP(PPPoE and PPTP) connection to 255.255.255.255.
	Reason: attempt to solve the routing problem when using dual WANs in BellSouth network.
3. Fixed the problem with FTP failing when the RV042 had Load Balancing enabled.
4. Fixed the problem of PPTP Pass Through in Multi-WAN environment.

v1.3.6.2	2005/03/28 
1. Fixed connection issue with certain Bell South ISP customers.

v1.3.6.1	2005/03/23 11:35:30
1. Fix the packet lost issue when Dual-WAN connections are being used.

v1.3.6		2004/12/30
1. Modify display logic of DDNS status.
2. Fixed WAN1/WAN2 does not work when WAN1 and WAN2 are connected to the same subnet / ISP concurrently.

v1.3.5		2004/12/24
1. Fixed remote management connection problem by using HTTPS.
2. Fixed Peanut Hull DDNS doesnt work on WAN1.

v1.3.4		2004/12/20
1. Support Peanut Hull DDNS Service.
2. Fixed WAN2 doesnt work from DMZ range changed back to Dual WAN.
3. Fixed a SSH VPN Client connection problem with Group VPN (FQDN / User_FQDN).

v1.3.3		2004/12/09
1. Add the [VPN Client Access] page.
2. Allow users to specify DMZ port as an IP range in the [Setup/Network] page.
3. Fixed VPN tunnel can not be added after Group VPN connected by clients.
4. Fixed Multicast over PPPoE.
5. Fixed VPN IP Compression doesnt work.
6. Fixed the Netbios broadcast can not be over multiple VPN tunnel.

v1.3.2		2004/11/22
1. Fixed the Netbios broadcast over VPN tunnel failure.
2. Fixed VPN manual mode failure.
3. Add 3322.org support in DDNS page.

v1.3.1		2004/09/24
1. Fix PPPoE connection problem with Westell/Bell South. 
2. Fix packets received by neighboring port on LAN side.
3. Fix the system crash caused by IP fragments.
4. Fix the system stalled due to protocol binding setting.
5. Fix the routing problem after DHCP client release its IP.
6. Fix the problem on adding more than two protocol binding rules.
7. Fix the problem on removing equalizer after failed on NSD.
8.Fix one to one NAT problem.
9.Fix UPnP interoperability with MSN.
10.Fix the syslog stalled problem while hiting with heavy loaded events.
11.Enhance the NAT session cleanup logic for setting up session efficiently.
12.Fix UPnP Presentation URL from /index.cgi to /.
13.Add a rectangle button on choosing descending/ascending order on [System Log] page.  

v1.3.0		2004/08/18
1. Support full-range remote management port setting
2. Support full-range configurable Load-balance bandwidth
3. Support the Network Service Detection functionality.
   Purpose: It detects the connectivity between Router and specified host.
   It will log messages or remove connection when connection dropped.
4. Support the Protocol Binding functionality. It allows users to specify IP or/and service passing through the specified WAN port.
5. Remove the Bandwidth Threshold options. Because it got hard to understand when it working together with the Protocol Binding.
6. Support the DNS Resolved functionality. It allows users to specify the IPSec Remote Security Gateway IP as a DDNS name.
 


