EDSPPORT BETA 1.00 Release Notes
5/15/97 Henry Cheng
_____________________________________________________________________________

INSTALLATION:

        1) Run SETUP.EXE from this diskette.
        2) Select I/O Ports, IRQ, and COM port at the installation menu.
        3) Select OK to continue, CANCEL to cancel the installation. 
        4) Use the Modem icon in Control Panel to install the modem, it will
           automatically detect the EDSPPORT modem, do not choose this item
           manually.
        5) That's it!

UNINSTALLATION:
	1) Use the devices icon in the control panel to stop  EDSP Port Driver.
	2) Use the modem icon in control panel to remove the modem.
	3) Run regedit, delete registry HKEY_LOCAL_MACHINE\SYSTEM\
	   CurrentControlSet\Services\EdspPort.
		
KNOWN PROBLEMS:

        1) SETUP cannot detect resource conflicts, beware of IRQs used by PCI
           bus.  Refer to CMOS SETUP or system start messages to locate IRQ
           usage.  This will be fixed at a later time... it may never work
           100% as NT 4.0 does not have Plug n Play.
        2) SETUP cannot detect system COM port usage and may allow user
           selection of UART supported COM ports, this will be fixed at a
           later time.  Check the Ports icon prior to running SETUP to
           existing COM port usage.
        3) Fax does not work, implementation and debug is not complete.
        4) The ES2820 chip on the current 2 layer board cannot fire IRQs
           7, 10 , and 12, SETUP has been modified accordingly.           

COMPATIBILITY:
        1) NT 4.0 Hyperterminal
        2) NT 4.0 RAS
        3) 16bit Terminal from Win3.1

