DIAGNOSTIC PROGRAM FOR DE-650CT
DEFAULT CABLE TYPE CHANGE PROGRAM FOR DE-650CT
-----------------------------------------------

Contents
--------
DMCU     EXE    Change connector program
README   W95    How to use DMCU.EXE
DLKDIAG  EXE    Diagnostic program
ODIDRV   COM    ODI driver for diagnostic program
DCD16    EXE    Enabler for DE-650CT
NET      CFG    ODI configuration file
IPXODI   COM    ODI configuration file
LSL      COM    ODI configuration file
README   TXT    This file

1. Diagnostic program
You will need to run this in DOS MODE ONLY. Please don't run in
Windows 95 or Windows NT DOS BOX. In Windows 95 you can press F8 when
you see 'Starting Windows 95.....' and go to Command Prompt. For NT
you will need to boot from a DOS diskette.

2. DMCU default cable type program
The program DMCU.EXE allows you to change the default setting  to
BNC or UTP. Please run the program DCD16.EXE & then DMCU.EXE; then
select the type of cable you are using. The program can also be run
from within Windows 95 but not from NT.

Note: D-Link drivers should normally switch the cable on load but
      NE2000 compatible drivers will select the default only.


