******************************************************************************
*                       ASMPRO Server Agent for NetWare                      *
*                       ASMPRO V4.50                                         *
******************************************************************************

This README file provides you installation instructions of ASMPRO Agent for
NetWare and some important information to configure and run this software.

MAKE SURE SNMP IS CONFIGURED PROPERLY

    ASMPRO Server Agent requires SNMP.NLM running with Control Community set to
    'public'. Otherwise, ASMPRO Station cannot set any object in ASMPRO Server Agent,
    and cannot receive SNMP Trap from ASMPRO Agent.

    ASMAGENT.NCF, the script file which loads all related
    modules of ASMPRO Agent, loads SNMP by the following command:

        load snmp control=public

    If you load SNMP.NLM before ASMPRO Agent, make sure the Control Community
    has been set properly. For more information, please refer to related
    documents about the SNMP Agent for NetWare (NetWare SNMP).

    Please check your AUTOEXEC.NCF to see if you have loaded SNMP. Notice
    that because of the autoloading feature of NLM, it's not obvious
    to find out where the SNMP is loaded. The most common is TCPIP.NLM which
    autoloads SNMP.NLM. If you are using TCPIP, load SNMP by the command line

        load snmp control=public

    before loading TCPIP.

    For NetWare 4.x users, if you are using INETCFG.NLM to configure the
    network, be sure to configure SNMP as expected.


INSTALLATION PROCUDURE (DISKETTE):

1.  Insert this diskette to the floppy drive of server.

2.  From NetWare System Console, type
        LOAD A:SETUP

    The drive letter depends on the floppy drive. It may be A: or B:.

3.  Follow the instructions SETUP prompts you.


INSTALLATION PROCUDURE (CD-ROM):

1.  Mount the CD-ROM volume.

2.  From NetWare System Console, type
        LOAD VOLNAME:DIRECTORY\SETUP

    Where VOLNAME is the volume name of the CD-ROM.
    DIRECTORY is the directory path of SETUP.NLM.

3.  If the CD-ROM drive is accessible from DOS, the alternative is typing
        LOAD D:\DIRECTORY\SETUP

    The drive letter depends on the CD-ROM drive. It may be D:, E:, etc.
    DIRECTORY is the directory path of SETUP.NLM.

4.  Follow the instructions SETUP prompts you.


******************************************************************************

How to enable RDM function in NetWare?
    By default, RDM function is enabled after ASMPRO Agent is loaded. User
    has to manually enable it only when it was disabled.

    From NetWare System Console, type
        rdmtest start

How to disable RDM function in NetWare?
    From NetWare System Console, type
        rdmtest cancel

How to simulate system hang in NetWare?
    From NetWare System Console, type
        rdmtest down


******************************************************************************
*                       Back Plane Board Agent for NetWare                   *
*                       V4.3                                                 *
******************************************************************************

MAKE SURE GAM SERVER V3.0 FOR NETWARE IS INSTALLED PROPERLY

    BPB Agent requires that Mylex GAM Server V3.0 be installed and running
    properly. Please check this prior to installing BPB Agent.
