******************************************************************************
*                       ASM Agent for NetWare                                *
*                       ASM Pro V3.15                                        *
******************************************************************************

This README file provides you installation instructions of ASM Agent for
NetWare and some important information to configure and run this software.

MAKE SURE SNMP IS CONFIGURED PROPERLY

    ASM Agent requires SNMP.NLM running with Control Community set to
    'public'. Otherwise, ASM Station cannot set any object in ASM Agent,
    and cannot receive SNMP Trap from ASM Agent.

    ASMAGENT.NCF, the script file which loads all related
    modules of ASM Agent, loads SNMP by the following command:

        load snmp control=public

    If you load SNMP.NLM before ASM Agent, make sure the Control Community
    has been set properly. For more information, please refer to related
    documents about the SNMP Agent for NetWare (NetWare SNMP).

    Please check your AUTOEXEC.NCF to see if you have loaded SNMP. Notice
    that because of the autoloading feature of NLM, it's not obvious
    to find out where the SNMP is loaded. The most common is TCPIP.NLM which
    autoloads SNMP.NLM. If you are using TCPIP, load SNMP by the command line

        load snmp control=public

    before loading TCPIP.

    For NetWare 4.x users, if you are using INETCFG.NLM to configure the
    network, be sure to configure SNMP as expected.


INSTALLATION PROCUDURE (DISKETTE):

1.  Insert this diskette to the floppy drive of server.

2.  From NetWare System Console, type
        LOAD A:SETUP

    The drive letter depends on the floppy drive. It may be A: or B:.

3.  Follow the instructions SETUP prompts you.


INSTALLATION PROCUDURE (CD-ROM):

1.  Mount the CD-ROM volume.

2.  From NetWare System Console, type
        LOAD VOLNAME:DIRECTORY\SETUP

    Where VOLNAME is the volume name of the CD-ROM.
    DIRECTORY is the directory path of SETUP.NLM.

3.  If the CD-ROM drive is accessible from DOS, the alternative is typing
        LOAD D:\DIRECTORY\SETUP

    The drive letter depends on the CD-ROM drive. It may be D:, E:, etc.
    DIRECTORY is the directory path of SETUP.NLM.

4.  Follow the instructions SETUP prompts you.


******************************************************************************

How to enable RDM function in NetWare?
    By default, RDM function is enabled after ASM Agent is loaded. User
    has to manually enable it only when it was disabled.

    From NetWare System Console, type
        rdmtest start

How to disable RDM function in NetWare?
    From NetWare System Console, type
        rdmtest cancel

How to simulate system hang in NetWare?
    From NetWare System Console, type
        rdmtest down

