------------------------------------------------------------------
Windows NT drivers

These drivers are necessary when using the native NT backup application and a number of other 3rd-party backup applications.

In all cases first remove the native Windows NT driver or any other DAT or DLT driver, before starting the installation of the HP DAT or DLT driver respectively.

The following instructions are also valid to remove drivers, by simply choosing the 'remove' option instead of the 'add' option.

For the latest driver support for HP tape drives, please visit  
the following HP web sites :
//www.hp.com/go/cposupport
//www.hp.com/go/connect


Installing Windows NT 4.0 drivers
---------------------------------

1   Log on to Windows NT as Administrator, supplying the necessary  
     password.

2   Click on the 'Start' button, and then 'Settings' and 'Control  
     Panel'.  

3   Double-click on the 'Tape Devices' icon.

4   The system will scan for attached tape drives and display a  
     message saying that a new SCSI device has been found. Click on  
     'Cancel' to proceed with installing the driver.  

5   Click on the 'Drivers' tab, then on the 'Add' button and finally  
     on the 'Have Disk' button.  

6   Depending on the state of your system, you may be prompted to  
     enter the path name for the driver e.g.  
     "C:\TEMP\DDS4"
     The 'Install Driver' dialog box will show the tape
     driver. Select it and click 'OK'.

7   You normally need to re-boot the system, unless the tape driver  
     is the first tape driver installed on your system. In this case,
     the Tape Devices dialog box will display the "driver loaded"  
     message. Close this window. You should be able to use your new  
     tape drive.


-------------------------------------------------------------------
