[SYS BIOS]
1. No change.

[EC BIOS]

1. Fix sometimes can't charge 2nd battery when voltage was too low that causes communication fail if system with main/2nd battery.

-----------------------------------------------------------------------------
+================================================================+
| EDL00 BIOS FLASH/CRISIS USAGE 
+================================================================+
1. formal flash process
a). Load DOS's TSR to high memory.
* Confirm HIMEM.SYS is in your boot disk, you can find it in DOS.
* Assume HIMEM.SYS reside in c:\, add following statement in CONFIG.SYS:
DEVICE=C:\HIMEM.SYS
DOS=HIGH
b). Copy all files to thumb or hard disk. Note that can't use floppy disk,
as it's size is too small to execute following steps.
c). Boot into DOS.
d). Execute <flash.bat> and wait for all process done. In this step, it will
produce all.rom that has flash capability. It is suitable for your
platform's vga and lan chip.

2. Build all sku's rom
Execute buildrom.bat within <EDL00_250.zip> under Windows mode, then it will create rom files of
various SKU. (43M.rom, 43Mdock.rom, 44MV.rom, 44MVDock.rom, UMA.rom, UMADock.rom)

3. Using crisis
a). Using the buildrom.bat to create 512k rom (43M.rom, 43Mdock.rom, 44MV.rom, 44MVDock.rom, UMA.rom, UMADock.rom) which match with your platform,
and then rename it to bios.rom.
b). Copy bflashit.bin and bios.rom to floppy disk.
c). Plug in AC and floppy disk to your system.
d). Press Fn+Esc and don't release.
e). Press power button, and then release Fn+Esc.
f). Wait crisis to be finished.
===========================================================
+==========================================================+
| EDL00 BIOS WINDOWS FLASH USER'S GUIDE 
+==========================================================+
1. Copy all files to thumb or hard disk. Note that can't use floppy disk, as it's size is too small to execute following steps.
2. The environment must be under windows mode, because the flash tool need to run in windows system.
3. Execute <flash.bat> to update BIOS.
4. When the flash status finished, that will show a window message to tell you need to shutdown system for completing the BIOS update, please click "OK".
It will help you to shutdown system.
